Release Notes for Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Release 12.2(40)EX

Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(40)EX1

OL-12250-01

Open Caveats

The delay can increase, up to 30 minutes, depending on the number of SVIs that are attached to the

policy map. The delay does not affect the operation of the policy-map. However, either of these

workarounds will reduce the length of the delay:

–

Remove the access control entries (ACEs) from the destination ACL, leaving the ACL empty.

(The effect is the same as removing the ACL itself.)

–

Detach the affected policy-maps from all the attached VLANs and SVIs, remove the ACL from

the policy-maps, and then reattach the policy-maps back to the original SVIs.

• CSCsj77933

If you enter a space before a comma in the define interface-range or the interface range global

configuration command, the space before the comma is not saved in the switch configuration.

There is no workaround.

• CSCsk19926

Traffic is not received on a member port in a switch stack under these conditions:

–

The port is in a cross-stack EtherChannel.

–

One or more of the master switch Cisco TwinGig Converter Module ports are in the cross-stack

EtherChannel.

–

This member switch has been reloaded.

The workaround is to enter the shutdown and no shutdown interface configuration commands on

the affected interface or to reload the entire stack instead of a single member switch.

• CSCsl49153

You might receive a traceback message when you use the no interface port-channel global

configuration command to delete interfaces from an EtherChannel that has port channels on multiple

stack members.

The workaround is to save the configuration and to reload the stack.

• CSCsl63862

When you use the switch renumber global configuration command to renumber a member switch

in a switch stack and then reload the switch, the internal server-facing ports do not have the required

default of spanning-tree portfast enabled.

The workaround is to apply the switch provision configuration before you reboot the switch.

Enter

both the switch current-stack-member-number renumber new-stack-member-number and the

switch stack-member-number provision type global configuration commands, and reload the

switch.

• CSCso15367

The CLI output for the StackWise Plus port 2 shows the output for the StackWise Plus port 1 and

vice versa.

There is no workaround.