Release Notes for Cisco Catalyst Blade Switch 3120 for HP Cisco IOS Release 12.2(40)EX

19
Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(40)EX1
OL-12250-01
Open Caveats
• CSCsi01526
Traceback messages appear if you enter the no switchport interface configuration command to
change a Layer 2 interface that belongs to a port channel to a routed port.
There is no workaround.
• CSCsi06399
When a RIP network and IP address are configured on an interface, a traceback error occurs after
you enter the shutdown, no shutdown, switchport, and no switchport interface configuration
commands.
The workaround is to configure the RIP network and the IP address after you configure the interface.
• CSCsi14303
When booting a switch stack configured for IP source guard with port security and dynamic ARP
inspection, a message similar to this might appear:
SYS-2-LINKED: Bad enqueue of 2A3DE74 in queue 22881BC (l3a3-9) -Process=
"Port-Security", ipl= 6, pid= 161 (l3a3-9) -Traceback= 119CC50 11D2264 9571E0 119B4E0
95D41C 80DBD8 80E734 80B998 80AAD4 80B55C 9EB158 9E2544 (l3a3-9)
There is no workaround. This message is only information; switch functionality is not affected.
• CSCsi16162
When you enter an all 0s route with an all 1s mask in the routing table and the next hop is entered
as an interface, a traceback message appears.
The workaround is to use an IP address as the next hop instead of an interface.
• CSCsi26444
The error message %DOT1X_SWITCH-5-ERR_VLAN_NOT_FOUND might appear for a switch stack under
these conditions:
– IEEE 802.1 is enabled.
– A supplicant is authenticated on at least one port.
– A new member joins a switch stack.
You can use one of these workarounds:
– Enter the shutdown and the no shutdown interface configuration commands to reset the port.
– Remove and reconfigure the VLAN.
• CSCsi50367
When changing a switch port access VLAN from static to dynamic or the reverse, a message similar
to this might appear:
01:43:55: PSECURE: Assert failure: is_etherchnl(hwidb_or_null swidb)):
../switch/psecure/psecure_ifc.c: 412: psecure_get_vlanid (l2a1-5) 01:43:55Traceback=
804484 809604 802258 806904 70FC 8D70 5C97BC 6901DC 6903CC 9EF8D8 9E6CC4 (l2a1-5)
There is no workaround necessary. This message does not affect switch functionality.
• CSCsi52914
When you are configuring a SPAN session, this message might erroneously appear even when two
source sessions are not configured:
% Platform can support a maximum of 2 source sessions
The workaround is to reboot the switch stack.