Cisco Catalyst Blade Switch 3120 for HP System Message Guide

2-76

OL-12249-01

Chapter 2 Message and Recovery Procedures

SDM Messages

Error Message RMON-5-RISINGTRAP: Rising trap is generated because the value of

[chars] exceeded the rising-threshold value [dec].

Explanation

A rising trap has been generated. The value of the specified MIB object has exceeded

the rising threshold value. [chars] is the MIB object, and [dec] is the threshold value.

Recommended Action Take appropriate action on the specified object.

SDM Messages

This section contains the Switch Database Management (SDM) message.

Error Message SDM-6-MISMATCH_ADVISE: [chars].

Explanation

A stack member cannot support the SDM template that the stack master is using.

Switches in the SDM mismatch state are not functional stack members. This error follows the

STACKMGR-6-SWITCH_ADDED_SDM error message if it reports SDM_MISMATCH. [chars]

displays mismatch information and recommended corrective actions.

Recommended Action Downgrade the SDM template of the stack master to make it compatible with

the stack member switches. For example, if the stack master uses the aggregator routing template,

the message recommends downgrading the stack master to the desktop routing template by using the

sdm prefer vlan desktop global configuration command.

SPAN Messages

This section contains the Switched Port Analyzer (SPAN) messages.

Error Message SPAN-3-MEM_UNAVAIL: Memory was not available to perform the SPAN

operation.

Explanation

The system was unable to perform a SPAN operation because of a lack of memory.

Recommended Action Reduce other system activity to ease the memory demands.

Error Message SPAN-3-SESS_DEC_CFG: SPAN hardware resource is in use. [chars]

Explanation

The system could not allocate a SPAN hardware resource for the feature specified in the

error message. It is possible that a distributed EtherChannel has been configured in the system that

is using a SPAN hardware resource.

Recommended Action Remove one or all of the distributed EtherChannels from the system and retry

the operation.