Cisco Catalyst Blade Switch 3120 for HP System Message Guide

2-74

OL-12249-01

Chapter 2 Message and Recovery Procedures

QOSMGR Messages

Error Message QOSMGR-4-CLASS_NOT_SUPPORTED: Classification is not supported in

classmap [chars].

Explanation

An unsupported match class-map configuration command was configured in a policy

map and attached to an egress interface, or more than one match class-map command was

configured. This is a hardware limitation. [chars] is the class-map name.

Recommended Action Reconfigure the class map or the policy map. Use only the match ip dscp

dscp-list class-map configuration command in a policy map that is attached to an egress interface.

Only one match per class map is supported.

Error Message QOSMGR-4-COMMAND_FAILURE: Execution of [chars] command failed.

Explanation

The command to configure a QoS setting failed. This is possibly due to lack of hardware

resources. [chars] is the description of the command.

Recommended Action Check if any other messages indicate resource failure. If other messages

indicate that the hardware resources are exceeded, retry the command with a smaller configuration.

Find out more about the error by using the show tech-support privileged EXEC command and by

copying the error message exactly as it appears on the console or system log and entering it in the Output

Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For more information about

these online tools and about contacting HP, see the “Error Message Traceback Reports” section on

page 1-5.

Error Message QOSMGR-4-HARDWARE_NOT_SUPPORTED: Hardware limitation has reached for

policymap [chars].

Explanation

The policy-map configuration has exceeded the limitation of the hardware. You

configured more QoS ACL entries than the number specified in the Switch Database Management

(SDM) template. [chars] is the policy-map name.

Recommended Action Reconfigure the class map or the policy map, and reduce the number of QoS

ACLs.

Error Message QOSMGR-4-MATCH_NOT_SUPPORTED: Match type is not supported in classmap

[chars].

Explanation An unsupported match type was entered. Only the access-group acl-index-or-name, ip

dscp dscp-list, and ip precedence ip-precedence-list match types are supported with the match

class-map configuration command. [chars] is the class-map name.

Recommended Action Reconfigure the class map; use only the match access-group, match ip dscp,

and match ip precedence class-map configuration commands within the class map.