Cisco Catalyst Blade Switch 3120 for HP System Message Guide

2-69

OL-12249-01

Chapter 2 Message and Recovery Procedures

PORT_SECURITY Messages

Error Message PM-4-VMPS_CFG: Dynamic access VLAN [dec] same as voice vlan on [chars].

Explanation

The access VLAN ID on the VMPS server is the same as the voice VLAN ID on the

interface. [dec] is the access VLAN ID, and [chars] is the physical interface.

Recommended Action Assign the access VLAN on the VMPS server to a VLAN ID that is different

from the voice VLAN ID.

PORT_SECURITY Messages

This section contains the port security messages.

Error Message PORT_SECURITY-2-PSECURE_VIOLATION:Security violation occurred caused

by MAC [enet] on port [chars].

Explanation

An unauthorized device attempted to connect on a secure port. MAC [enet] is the MAC

address of the unauthorized device, and port [chars] is the secure port.

Recommended Action Identify the device that attempted to connect on the secure port. Notify your

network system administrator of this condition.

Error Message PORT_SECURITY-2-PSECURE_VIOLATION_VLAN: Security violation on port

[chars] due to MAC address [enet] on VLAN [dec]

Explanation

An unauthorized device attempted to connect on a secure trunk port. [chars] is the

secure port, MAC [enet] is the MAC address of the unauthorized device, and [dec] is the VLAN ID.

Recommended Action Identify the device that attempted to connect through the secure trunk port.

Notify your network system administrator of this condition.

Error Message PORT_SECURITY-6-ADDR_REMOVED: Address [dec]:[enet] exists on port

[chars]. It has been removed from port [chars].

Explanation

A routed port is reconfigured as a switch port. The address in the previous switch

configuration conflicts with the running configuration and has been deleted. [dec]:[enet] is the MAC

address of the port. [chars] is the reconfigured port.

Recommended Action No action is required.

Error Message PORT_SECURITY-6-ADDRESSES_REMOVED: Maximum system secure address count

reached. Some secure addresses configured on port [chars] removed.

Explanation Some configured and sticky MAC addresses on the specified port were removed from

the configuration. The number of secure addresses that the system supports was exceeded. This

condition occurs only during hot swapping or port-mode changes (for example, when the port is

converted from a Layer 3 to a Layer 2 port). [chars] is the port.

Recommended Action No action is required.