Cisco Catalyst Blade Switch 3120 for HP System Message Guide

2-59

OL-12249-01

Chapter 2 Message and Recovery Procedures

PLATFORM_UCAST Messages

Error Message PLATFORM_UCAST-3-HSRP: [chars].

Explanation

The Hot Standby Router Protocol (HSRP) module for unicast routing encountered an

error. [chars] describes the error.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the “Error Message Traceback Reports” section on page 1-5.

Error Message PLATFORM_UCAST-3-INTERFACE: [chars].

Explanation A unicast routing interface error occurred. [chars] describes the error.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the “Error Message Traceback Reports” section on page 1-5.

Error Message PLATFORM_UCAST-3-RPC: [chars].

Explanation

The RPC module for unicast routing encountered an error. [chars] describes the error.

Error Message Copy the message exactly as it appears on the console or in the system log. Research and

attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to look for similar

reported problems. If you still require assistance, contact HP technical support and provide the

representative with the gathered information. For more information about the online tools and about

contacting HP, see the “Error Message Traceback Reports” section on

page 1-5.

PLATFORM_UCAST-6-PREFIX: One or more, more specific prefixes could not be

programmed into TCAM and are being covered by a less specific prefix

Explanation

A more specific prefix could not be programmed into Ternary Content Addressable

Memory (TCAM) and is covered by a less specific prefix. This could be a temporary condition. The

output of the show platform ip unicast failed route privileged EXEC command lists the failed

prefixes.

Recommended Action No action is required.