Manualshelf

Cisco Catalyst Blade Switch 3120 for HP System Message Guide

ManualsBrandsHP ManualsComputer AccessoriesCisco Catalyst 1GbE 3120G Blade Switch
61626364656667686970
2-52
Cisco Catalyst Blade Switch 3120 for HP System Message Guide
OL-12249-01
Chapter 2 Message and Recovery Procedures
PLATFORM_IPv6_UCAST Message
Error Message PLATFORM_IPC-3-MEMBER: [chars].
Explanation
There has been an IPC failure on a stack member switch. [chars] describes the error
message.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the “Error Message Traceback Reports” section on page 1-5.
Error Message PLATFORM_IPC-3-STACK_EVENT: [chars].
Explanation There has been an IPC failure in the stack. [chars] describes the error message.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, contact HP technical support and
provide the representative with the gathered information. For more information about the online
tools and about contacting HP, see the “Error Message Traceback Reports” section on page 1-5.
PLATFORM_IPv6_UCAST Message
This section contains the IP Version 6 Unicast message.
Error Message PLATFORM_IPv6_UCAST-6-PREFIX: One or more, more specific prefixes
could not be programmed into TCAM and are being covered by a less specific prefix
Explanation
A more specific prefix could not be programmed into Ternary Content Addressable
Memory (TCAM) and is covered by a less specific prefix. This could be a temporary condition. The
output of the show platform ipv6 unicast retry route privileged EXEC command lists the failed
prefixes.
Recommended Action No action is required.
PLATFORM_PBR Messages
This section contains policy based routing (PBR) messages.
Error Message PLATFORM_PBR-2-NO_RMAP: Cannot create PBR data structures for
route-map [chars].
Explanation
The PBR manager could not allocate the internal data structures for this route-map. A
likely cause is lack of available memory. [chars] is the route-map.
Recommended Action Simplify the configuration so that it requires less memory.