Cisco Catalyst Blade Switch 3120 for HP System Message Guide

2-43

OL-12249-01

Chapter 2 Message and Recovery Procedures

IMAGEMGR Messages

Error Message IGMP_QUERIER-4-SNOOPING_DISABLED: The IGMP querier is operationally

disabled in VLAN [dec] because IGMP snooping has been disabled in this VLAN.

Explanation

IGMP snooping is disabled on this VLAN. Do not enable the IGMP querier when IGMP

snooping is disabled. [dec] is the VLAN IDs.

Recommended Action Confirm that IGMP snooping is enabled both globally and on the VLAN.

Error Message IGMP_QUERIER-6-PIM_DISABLED: The IGMP querier is now operationally

enabled in VLAN [dec] because PIM is no longer enabled on the SVI.

Explanation

Protocol-Independent Multicast (PIM) is disabled on the switch virtual interface (SVI),

and the IGMP querier function is now enabled. [dec] is the VLAN ID.

Recommended Action No action is required.

Error Message IGMP_QUERIER-6-SNOOPING_ENABLED: The IGMP querier is now operationally

enabled in VLAN [dec] because IGMP snooping is no longer disabled.

Explanation

IGMP snooping was enabled. As a result, the IGMP querier function is now enabled.

[dec] is the VLAN ID.

Recommended Action No action is required.

IMAGEMGR Messages

This section contains image manager messages, which are related to image compatibility within the

stack.

Error Message IMAGEMGR-6-AUTO_ADVISE_SW_INITIATED: Auto-advise-software process

initiated for systems [bits: [hex]].

Explanation

Systems with incompatible software have been detected in the switch stack.

Auto-advise software informs you when not all switches in the stack are running the same software

version. The stack master then attempts to upgrade all switches running different versions to the

version that the master is running. The stack finds out whether or not software is available to be

copied to the incompatible systems and if so, advises you how to copy it. Otherwise, the system

informs you that the software on the switch stack needs to be updated. [bits [hex]] is the bit

representation of the switch number.

Recommended Action No action is required.

Error Message IMAGEMGR-6-AUTO_ADVISE_SW: [chars].

Explanation

A line of output from the auto-advise-software process is being displayed. [chars] is a

text message reporting status of the upgrade process.

Recommended Action No action is required.