Cisco Catalyst Blade Switch 3120 for HP System Message Guide

2-42

OL-12249-01

Chapter 2 Message and Recovery Procedures

HPSECURE Messages

Error Message HLFM-3-SEND_FAIL: Failed to send RPC message, req [dec], [chars].

Explanation

There is a local resource error or that too many outgoing messages are queued for the

message class. [dec] is the RPC request number, and [chars] is an optional comment.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the “Error Message Traceback Reports” section on page 1-5.

HPSECURE Messages

This section contains port-security messages.

Error Message HPSECURE-6-ADDR_REMOVED: Address [enet]:[dec] on port [chars] cannot

be added on switch [dec] and has been removed.

Explanation At least one switch in the stack could not add the MAC address due to a resource failure,

and the MAC address has been deleted from all the switches in the stack. [enet] is the MAC address,

the first [dec] is the VLAN to which the MAC address is assigned, [chars] is the interface, and the

second [dec] is the stack member number.

Recommended Action No action is required.

IGMP_QUERIER Messages

This section contains the IGMP querier messages.

Error Message IGMP_QUERIER-4-NO_IP_ADDR_CFG: The IGMP querier cannot send out

General Query messages in VLAN [dec] because there is no IP address configured on

the system.

Explanation

You must specify an IP address for the IGMP querier at either the global or per-VLAN

level. [dec] is the VLAN ID.

Recommended Action Configure a source IP address for the IGMP querier.

Error Message IGMP_QUERIER-4-PIM_ENABLED: The IGMP querier is operationally disabled

in VLAN [dec] because PIM has been enabled on the SVI.

Explanation PIM was detected on the SVI. Do not enable the IGMP querier when PIM is enabled on

the SVI. [dec] is the VLAN ID.

Recommended Action Ensure that PIM is disabled on the SVI.