Cisco Catalyst Blade Switch 3120 for HP System Message Guide

2-40

OL-12249-01

Chapter 2 Message and Recovery Procedures

HARDWARE Messages

Error Message HARDWARE-3-PORTNUM_ERROR: port number [dec] is invalid.

Explanation

The port number used is invalid (out of range). Each interface in a given port ASIC is

identified by an index value. [dec] is the port number.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the “Error Message Traceback Reports” section on page 1-5.

Error Message HARDWARE-3-THERMAL_NOT_FUNCTIONING: Temperature Sensor is not

functioning.

Explanation

The temperature sensor is not functioning, and the switch temperature behavior cannot

be determined.

Recommended Action Ensure that the ambient temperature is not too high. If the problem persists,

replace the component.

Error Message HARDWARE-3-STATS_ERROR: Statistics ID [dec] is invalid.

Explanation

The statistics ID used is out of range. The statistics supported by the port ASIC are

identified by an ID. [dec] is the statistics ID.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the “Error Message Traceback Reports” section on page 1-5.

Error Message HARDWARE-5-FAN_NOT_PRESENT: Fan is not present.

Explanation The fan is not in the switch.

Recommended Action Make sure the fan is completely inserted. If the fan is removable, remove and

replace it into the switch. If the problem persists after insertion, replace the fan.

Error Message HARDWARE-5-FAN_OK: Fan works fine.

Explanation

The fan is now working properly.

Recommended Action No action is required.

Error Message HARDWARE-5-FAN_OK: Fan works fine.

Explanation

This message means that the fan is now working properly.

Recommended Action No action is required.