Cisco Catalyst Blade Switch 3120 for HP System Message Guide

2-32

OL-12249-01

Chapter 2 Message and Recovery Procedures

EXPRESS_SETUP Messages

Error Message ETHCNTR-3-SNAP_FORWARDING_UNSUPPORTED: IPv4/IPv6 SNAP forwarding will

be disabled because switch [dec] does not support this feature.

Explanation

A switch that is being added to the stack does not support the forwarding of IP Version 4

(IPv4) and IP Version 6 (IPv6) frames with Subnetwork Access Protocol (SNAP) encapsulation. If

this occurs, forwarding of IPv4 and IPv6 frames is disabled in the switch stack. [dec] is the stack

member number.

Recommended Action Replace the stack member with a switch that supports forwarding of IPv4 and

IPv6 frames with SNAP encapsulation.

EXPRESS_SETUP Messages

This section contains the Express Setup messages that appear when you use a 10/100/1000 or the

Ethernet management port to connect to the PC. For Express Setup with the Ethernet management port,

see the CLS_ACC Messages section.

Error Message EXPRESS_SETUP-3-UNABLE_TO_RESET_CONFIG: [chars].

Explanation

The system is unable to reset the configuration. [chars] is a text string that explains why

the reset failed. For example,

error renaming config file, error removing config file, or

error removing private config file.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the “Error Message Traceback Reports” section on page 1-5.

Error Message EXPRESS_SETUP-6-CONFIG_IS_RESET: [chars].

Explanation The configuration is reset. [chars] is a text message that clarifies the reset event, such

The configuration is reset and the system will now reboot.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the “Error Message Traceback Reports” section on page 1-5.

Error Message EXPRESS_SETUP-6-MODE_ENTERED.

Explanation

The Express Setup mode is active.

Recommended Action No action is required.