Cisco Catalyst Blade Switch 3120 for HP System Message Guide

2-9

OL-12249-01

Chapter 2 Message and Recovery Procedures

CFGMGR Messages

This section contains the configuration manager messages.

Error Message CFGMGR-1-UNABLE_TO_SEND_RUN_CFG: unable to send running-cfg, bits:

[hex], retrying...

Explanation

The system is unsuccessfully attempting to distribute the running configuration to the

stack member switches. [hex] is the bit representation of the switch number.

Recommended Action Find out more about the error by using the show tech-support privileged

EXEC command and by copying the error message exactly as it appears on the console or system

log and entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported

problems. For more information about these online tools and about contacting HP, see the “Error

Message Traceback Reports” section on page 1-5.

Error Message CFGMGR-1-UNABLE_TO_SEND_STARTUP_CFG: unable to send startup-cfg, bits:

[hex], retrying...

Explanation

The system is unsuccessfully attempting to distribute the startup configuration file to the

stack member switches. [hex] is the bit representation of the switch number.

Recommended Action Find out more about the error by using the show tech-support privileged EXEC

command and by copying the error message exactly as it appears on the console or system log and

entering it in the Output Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For

more information about these online tools and about contacting HP, see the “Error Message Traceback

Reports” section on page 1-5.

Error Message CFGMGR-3-ERROR_APPLYING_STARTUP_CFG: Error Applying Startup Config to

Running Config.

Explanation The system encountered an error when it was automatically applying the startup

configuration to the running configuration.

Recommended Action Copy the message exactly as it appears on the console or in the system log.

Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to

look for similar reported problems. If you still require assistance, contact HP technical support and

provide the representative with the gathered information. For more information about the online

tools and about contacting HP, see the “Error Message Traceback Reports” section on page 1-5.

Error Message CFGMGR-4-MEMBER_WRITING_STARTUP_CFG: only master can do that.

Explanation

A stack member switch attempted to write to the startup configuration file; only the

stack master can write to the startup configuration file.

Recommended Action No action is required.