Cisco Catalyst Blade Switch 3120 for HP System Message Guide

2-93

OL-12249-01

Chapter 2 Message and Recovery Procedures

SW_MATM

Error Message SW_MACAUTH-5-CLEAR_TABLE: MAC Authentication Table Cleared

Explanation

The MAC authentication table was cleared.

Recommended Action No action is required.

Error Message SW_MACAUTH-5-MACAUTH_ENADSA: MAC Authentication [chars]

Explanation MAC authentication is enabled or disabled. [chars] is the MAC authentication status,

either enabled or disabled.

Recommended Action No action is required.

Error Message SW_MACAUTH-5-MAC_AUTHENTICATED: MAC [enet] was authenticated

Explanation

The switch has received a command to authenticate a MAC address. [enet] is the MAC

address.

Recommended Action No action is required.

SW_MATM

This section contains the Mac Address Table Manager (MATM) message.

Error Message SW_MATM-4-MACFLAP_NOTIF: Host [enet] in [chars] [dec] is flapping

between port [chars] and port [chars]

Explanation

The switch found the traffic from the specified host flapping between the specified

ports. [enet] is the host MAC address, [chars] [dec] is the switch ID, and the first and second [chars]

are the ports between which the host traffic is flapping.

Recommended Action Check the network switches for misconfigurations that might cause a

data-forwarding loop.

SWITCH_QOS_TB Messages

This section contains the QoS trusted boundary (TB) messages.

Error Message SWITCH_QOS_TB-5-TRUST_DEVICE_DETECTED: [chars] detected on port

[chars], port's configured trust state is now operational.

Explanation

A trusted boundary detected a device matching the trusted device setting for the port and

has modified the port trust state. The first [chars] is the trusted device, and the second [chars] is the

port.

Recommended Action No action is required.