Release Notes for the Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 15.0(2)SE and Later

Table Of Contents

Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 15.0(2)SE and Later

OL-27316-02

Resolved Caveats

After rebooting a Cisco Catalyst Blade Switch 3012 (CBS3012), incorrect data is found in the vital

product data (VPD) of the switch, which causes the switch to become unmanageable.

There is no workaround.

• CSCui41032

Switch runs out of memory within few seconds of configuring the command privilege exec level

<n> show spanning-tree active/detail.

There is no workaround.

Caveats Resolved in Cisco IOS Release 15.0(2)SE4

• CSCuf77683

Internal VLANs are displayed when the show snmp mib ifmib ifindex command is entered or the

SNMP is queried for the ipMIB object.

The workaround is to check if the displayed VLANs are internal and then to hide them.

• CSCug62154

When the switch is started using TACACS+ configurations, the CPU utilization increases to 100%

and the VTY device does not work.

The workaround is to remove the TACACS+ configurations and restart the switch.

• CSCuh41077

The ipAddrEntry value in the IP Address Table shows an interface index that is not exposed by the

ifEntry Object ID.

There is no workaround.

Caveats Resolved in Cisco IOS Release 15.0(2)SE3

• CSCta43825

CPU usage is high when an SNMP Walk of the Address Resolution Protocol (ARP) table is

performed.

The workaround is to implement SNMP view using the following commands:

snmp-server view cutdown iso included

snmp-server view cutdown at excluded

snmp-server view cutdown ip.22 excluded

snmp-server community public view cutdown ro

snmp-server community private view cutdown rw

• CSCts95370

If an ACL is configured on a router VTY line for ingress traffic, the ACL is applied for egress traffic

also. As a result, egress traffic to another router on an SSH connection is blocked.

The workaround is to permit egress traffic to the specific destination router using the permit tcp

host <destination router IP address> eq 0 any interface configuration command.