Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(55)SE and Later

19
Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(55)SE and Later
OL-22860-04
Open Caveats
Beginning in privileged EXEC mode, follow these steps to configure the HTTP server interface:
If you use Internet Explorer Version 5.5 and select a URL with a nonstandard port at the end of the
address (for example, www.cisco.com:84), you must enter http:// as the URL prefix. Otherwise, you
cannot launch the device manager.
Open Caveats
• CSCth94904
An internal switch port is down when one of these HP Flex 10-Gigabit Ethernet network interface
cards (NICs) is up:
– Flex 522m Mezz
– Flex 542m Mezz
– Flex 552m Mezz
The workaround is to use the speed nonegotiate interface configuration command on the internal
port.
• CSCto57605
If the Dynamic Trunking Protocol (DTP) is set to speed nonegotiate for two switches that interface
each other, and the speed/duplex is configured as full/1000, the speed/duplex configuration of one
of the switches changes to auto/auto when the switch is restarted. The port channel becomes
incompatible and the second switch’s operation is suspended. This problem applies only to the
1000BASE-LX interface.
The workaround is to enter the shutdown interface configuration command followed by the no
shutdown command.
• CSCtx37129
If you enter the shutdown interface configuration command on the the Fast Ethernet 0 router
interface and VLAN 1 client switch interface, and then restart the master switch, the shutdown status
of these two interfaces are not shown correctly. If you check their status with the show
running-config privileged EXEC command, these interfaces are shown as up..
There is no workaround.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
ip http authentication {enable | local |
tacacs}
Configure the HTTP server interface for the type of authentication that
you want to use.
• enable—Enable password, which is the default method of HTTP
server user authentication, is used.
• local—Local user database, as defined on the Cisco router or access
server, is used.
• tacacs—TACACS server is used.
Step 3
end Return to privileged EXEC mode.
Step 4
show running-config Verify your entries.