Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(50)SE and Later

33
Release Notes for Cisco Catalyst Blade Switch 3120 for HP, Cisco IOS Release 12.2(50)SE and Later
OL-18270-03
Documentation Updates
Error Message %PAGP_DUAL_ACTIVE-3-OBJECT_CREATE_FAILED: Unable to create [chars]
Explanation
The switch cannot create the specified managed object. [chars] is the object name.
Recommended Action No action is required.
Error Message %PAGP_DUAL_ACTIVE-3-RECOVERY_TRIGGER: PAgP running on [chars]
informing virtual switches of dual-active: new active id [enet], old id [enet]
Explanation
Port Aggregation Protocol (PAgP) received a new active ID on the specified interface,
which means that all virtual switches are in a dual-active scenario. The interface is informing virtual
switches of this, which causes one switch to go into recovery mode. [chars] is the interface. The first
[enet] is the new active ID. The second [enet] is the ID that it replaces.
Recommended Action No action is required.
Error Message %PAGP_DUAL_ACTIVE-3-REGISTRY_ADD_ERR: Failure in adding to [chars]
registry
Explanation
The switch could not add a function to the registry. [chars] is the registry name.
Recommended Action No action is required.
Error Message %PHY-4-SFP_PLUS_NOT_SUPPORTED: The SFP PLUS in [chars] is not
supported
Explanation
The Cisco X2 transceiver module is not supported on the switch. [chars] is the port in
which the SFP module is inserted.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
tech-support user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case
with the TAC, or contact your Cisco technical support representative, and provide the representative
with the gathered information. For more information about these online tools and about contacting
Cisco, see the “Error Message Traceback Reports” section on page 2-7.
Error Message %PM-6-EXT_VLAN_ADDITION: Extended VLAN is not allowed to be configured
in VTP CLIENT mode.
Explanation
The switch did not add a VLAN in VTP client mode.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
“Error Message Traceback Reports” section in the system message guides.