Manualshelf

Cisco Catalyst Blade Switch 3120 for HP System Message Guide

ManualsBrandsHP ManualsComputer AccessoriesCisco Catalyst 1/10GbE 3120X Blade Switch
81828384858687888990
2-70
Cisco Catalyst Blade Switch 3120 for HP System Message Guide
OL-12249-01
Chapter 2 Message and Recovery Procedures
Protocol Tunneling Messages
Error Message PORT_SECURITY-6-VLAN_FULL: Vlan [dec] on port [chars] has reached its
limit. Address [enet] has been removed.
Explanation
The voice VLAN is the same as the access VLAN, and the maximum number of MAC
addresses reached the maximum limit allowed on the access VLAN. The address is deleted. [dec] is
the VLAN ID, [chars] is the port assigned to the voice VLAN and the access VLAN, and [enet] is
the MAC address that is deleted.
Recommended Action No action is required.
Error Message PORT_SECURITY-6-VLAN_REMOVED: VLAN [int] is no longer allowed on port
[chars]. Its port security configuration has been removed.
Explanation
A configured VLAN is not allowed either due to a port mode change or an allowed
VLAN list change and is removed from the configuration. [int] is the VLAN ID, and [chars] is the
switch port assigned to the VLAN.
Recommended Action No action is required.
Protocol Tunneling Messages
This section contains the protocol tunneling message.
Error Message PT-3-PT_HW_UNAVAIL: Protocol Tunneling hardware resource not
available. [chars]
Explanation Protocol tunneling could not be enabled because no redirect registers are available.
Protocol tunneling requires redirect registers. [chars] is the hardware resource that is not available.
Recommended Action Disable any applications that use redirect registers, and try configuring the
protocol tunneling again.
QOSMGR Messages
This section contains the quality of service (QoS) manager messages. An incorrect QoS setting causes
these messages.
Error Message QOSMGR-3-FEATURE_NOT_FOUND: Cannot find feature for [chars].
Explanation
An internal software error has occurred. [chars] is the description of the feature that the
software cannot find.
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Enter the show
running-config user EXEC command to gather data that might help identify the nature of the error.
Use the Bug Toolkit to look for similar reported problems. If you still require assistance, contact HP