Cisco Catalyst Blade Switch 3120 for HP System Message Guide

2-10
Cisco Catalyst Blade Switch 3120 for HP System Message Guide
OL-12249-01
Chapter 2 Message and Recovery Procedures
CFGMGR Messages
Error Message CFGMGR-5-UNABLE_TO_USE_PROVISIONED_CFG: Switch [dec] will receive the
default configuration.
Explanation
The switch type of the specified switch does not match the provisioned configuration
for its switch number; therefore, the default configuration is applied to this switch. [dec] is the stack
member number.
Recommended Action No action is required.
Error Message CFGMGR-6-APPLYING_RUNNING_CFG: as new master.
Explanation
A new stack master is applying the backed-up running configuration.
Recommended Action No action is required.
Error Message CFGMGR-6-SPURIOUS_MEMBER_ADD: CFG MGR Recvd Spurious New Member
Notification: [int].
Explanation
The configuration manager received a notification about adding a stack member switch
that already exists in the stack. [int] is the switch number.
Recommended Action If this message recurs, copy it exactly as it appears on the console or in the
system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug
Toolkit to look for similar reported problems. If you still require assistance, contact HP technical
support and provide the representative with the gathered information. For more information about
the online tools and about contacting HP, see the “Error Message Traceback Reports” section on
page 1-5.
Error Message CFGMGR-6-UNABLE_TO_NVGEN_BUSY_RUNNING_CFG: config file busy,
retrying...
Explanation The stack master is temporarily unable to generate the stack running configuration
because another process is generating the configuration file.
Recommended Action No action is required. The action will be tried again.
Error Message CFGMGR-6-UNABLE_TO_NVGEN_RUNNING_CFG: config file too large...
Explanation
The stack master is unable to generate the stack running configuration because the
configuration file is too large.
Recommended Action Remove some configuration commands.