Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide

Index
IN-46
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
STP (continued)
loop guard
described
19-11
enabling 19-18
modes supported 17-10
multicast addresses, effect of 17-9
optional features supported 1-7
overview 17-2
path costs 12-27
Port Fast
described
19-2
enabling 19-12
port priorities 12-26
preventing root switch selection 19-10
protocols supported 17-10
redundant connectivity 17-8
root guard
described
19-10
enabling 19-18
root port, defined 17-3
root port selection on a switch stack 17-3
root switch
configuring
17-16
effects of extended system ID 17-4, 17-16
election 17-3
unexpected behavior 17-16
shutdown Port Fast-enabled port 19-2
stack changes, effects of 17-12
status, displaying 17-24
superior BPDU 17-3
timers, described 17-22
UplinkFast
described
19-3
enabling 19-15
VLAN-bridge 17-11
stratum, NTP 6-2
stub areas, OSPF 38-31
stub routing, EIGRP 38-43
subdomains, private VLAN 15-1
subnet mask 38-7
subnet zero 38-7
success response, VMPS 12-29
summer time 6-13
SunNet Manager 1-5
supernet 38-8
SVIs
and IP unicast routing
38-5
and router ACLs 34-4
connecting VLANs 10-6
defined 10-5
routing between VLANs 12-2
switch console port 1-6
Switch Database Management
See SDM
switched packets, ACLs on
34-37
Switched Port Analyzer
See SPAN
switched ports
10-2
switchport block multicast command 25-7
switchport block unicast command 25-7
switchport command 10-16
switchport mode dot1q-tunnel command 16-6
switchport protected command 25-6
switch priority
MSTP
18-21
STP 17-21
switch software features 1-1
switch virtual interface
See SVI
synchronization, BGP
38-49
syslog
See system message logging
system clock
configuring
daylight saving time
6-13
manually 6-11
summer time 6-13
time zones 6-12