User's Manual

Removal and Installation
8-29
HP DesignJets 500, 510 and 800 Series Printers Service Manual
Scan-Axis Motor Assembly
Removal
WARNING Switch off the printer and remove the power cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the Left Hand Cover - Refer
to Page 8-5.
2. Remove the Right Hand Cover - Refer
to Page 8-7.
3. Remove the Power Supply - Refer to
Page 8-27.
4. Disconnect the Scan-Axis Motor
Cable from the Electronics Module.
5. Release the tension from the right
hand side of the Belt by pulling the
Tensioner down and pushing it
towards you to lock it into position.