HP LaserJet Pro MFP M225, M226 - Warranty and Regulatory Guide

Täiendavad avaldused telekommunikatsiooni- (faksi-) toodete
kohta
EL-i avaldus telekommunikatsioonitegevuse kohta
Käesolev toode on mõeldud ühendada Euroopa Majandusühenduspiirkonna (EEA) riikide/piirkondade
analoogsignaaliga fikstelefonivõrkudesse (PSTN).
See vastab 1999/5/EÜ direktiivile raadioseadmete ja telekommunikatsioonivõrgu lõppseadmete ning nende
nõuetekohasuse vastastikuse tunnustamise kohta (Lisa II) ja sel on vastav CE vastavuse tähis.
Täiendavad üksikasjad leiate tootjapoolsest vastavusdeklaratsioonist käesoleva kasutusjuhendi teises
jaotises.
Kuna eri riikide PSTN-id on erinevad, ei pruugi toode garanteerida edukat toimimist igas PSTN-i lõpp-punktis.
Võrgu ühilduvus sõltub kliendi poolt valitud õigest PSTN-ga ühendamise seadest. Järgige palun
kasutusjuhendi juhiseid.
Kui teil on probleeme võrguühilduvusega, võtke ühendust seadme tarnija või HP kasutajatoega kasutamise
riigis/regioonis.
Ühendamine PSTN lõpp-punkti võib kaasa tuua lisanõuded kohaliku PSTN operaatori poolt.
New Zealand Telecom Statements
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that
the item complies with minimum conditions for connection to its network. It indicates no endorsement of the
product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any
item will work correctly in all respects with another item of Telepermitted equipment of a different make or
model, nor does it imply that any product is compatible with all of Telecom’s network services.
This equipment may not provide for the effective hand-over of a call to another device connected to the
same line.
This equipment shall not be set up to make automatic calls to the Telecom “111” Emergency Service.
This product has not been tested to ensure compatibility with the FaxAbility distinctive ring service for New
Zealand.
Additional FCC statement for telecom products (US)
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the
back of this equipment is a label that contains, among other information, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
The REN is used to determine the quantity of devices, which may be connected to the telephone line.
Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In
most, but not all, areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of
devices that may be connected to the line, as determined by the total RENs, contact the telephone company
to determine the maximum REN for the calling area.
This equipment uses the following USOC jacks: RJ11C.
An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is
designed to be connected to the telephone network or premises wiring using a compatible modular jack,
40 Peatükk 3 Normatiivne teave ETWW