HP LaserJet Pro MFP M225, M226-Warranty and legal information

팩스 제품에 대한 추가 조항
통신 운영을 위한 EU 규정
이 제품은 유럽경제지역(EEA) 국가/지역의 아날로그 공중 전화망(PSTN) 연결에 맞게 설계되었습니다.
EU R&TTE 지침 1999/5/EC (부록 II)의 요구사항에 부합하며 이에 따라 해당 CE 준수 마크가 제품에 부착되었
습니다.
자세한 내용은 이 설명서의 다른 부분에 있는 제조업체의 자기 인증 선언을 참조하십시오.
그러나 각 국가/지역의 PSTN이 서로 다를 수 있기 때문에 모든 PSTN 종단 지점에서의 정상적인 작동을 조건
없이 보증할 수는 없습니다. 네트워크 호환성은 고객이 제품을 PSTN에 연결할 때 올바른 설정을 선택했느냐
에 달려 있습니다. 사용 설명서에 제공된 방법을 따르십시오.
네트워크 호환성에 문제가 있는 경우, 해당 국가/지역의 장비 공급업체 또는 HP 헬프 데스크로 문의하시기
바랍니다.
PSTN 종단점 연결은 인근 PSTN 운영자가 요청하는 추가 요구사항이 필요할 수도 있습니다.
New Zealand Telecom Statements
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that
the item complies with minimum conditions for connection to its network. It indicates no endorsement of the
product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any
item will work correctly in all respects with another item of Telepermitted equipment of a different make or
model, nor does it imply that any product is compatible with all of Telecom’s network services.
This equipment may not provide for the effective hand-over of a call to another device connected to the
same line.
This equipment shall not be set up to make automatic calls to the Telecom “111” Emergency Service.
This product has not been tested to ensure compatibility with the FaxAbility distinctive ring service for New
Zealand.
Additional FCC statement for telecom products (US)
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the
back of this equipment is a label that contains, among other information, a product identifier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
The REN is used to determine the quantity of devices, which may be connected to the telephone line.
Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming call. In
most, but not all, areas, the sum of the RENs should not exceed five (5.0). To be certain of the number of
devices that may be connected to the line, as determined by the total RENs, contact the telephone company
to determine the maximum REN for the calling area.
This equipment uses the following USOC jacks: RJ11C.
An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is
designed to be connected to the telephone network or premises wiring using a compatible modular jack,
which is Part 68 compliant. This equipment cannot be used on telephone company-provided coin service.
Connection to Party Line Service is subject to state tariffs.
38
3 장 형식 승인 KOWW