HP LaserJet Pro MFP M225, M226-Warranty and Legal Guide

電信（傳真）產品的附加聲明
歐盟電信作業聲明
本產品能夠連接至歐洲經濟區域 (EEA) 國家/地區中的類比公共交換電訊網路 (PSTN)。
它符合 EUR&TTE Directive 1999/5/EC (Annex II) 並貼有適用的 CE 相容性標章。
如需詳細資訊，請參閱本手冊其他章節中由廠商所發佈的相容性宣告。
由於各別國家/地區 PSTN 之間的差異，無法絕對保證產品能在每個 PSTN 終端點順利操作。網路相容性
牽涉到客戶針對 PSTN 連線所選擇的正確設定值。請按照使用手冊中的指示進行。
如果您遭遇網路相容性問題，請聯絡您的設備供應商或是作業所在國家/地區的 HP 服務中心。
連接至 PSTN 終端點可能包含了需由當地 PSTN 業者進行設定的額外需求。
New Zealand Telecom Statements
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted that the
item complies with minimum conditions for connection to its network. It indicates no endorsement of the
product by Telecom, nor does it provide any sort of warranty. Above all, it provides no assurance that any item
will work correctly in all respects with another item of Telepermitted equipment of a dierent make or model,
nor does it imply that any product is compatible with all of Telecom
’s network services.
This equipment may not provide for the eective hand-over of a call to another device connected to the same
line.
This equipment shall not be set up to make automatic calls to the Telecom “111” Emergency Service.
This product has not been tested to ensure compatibility with the FaxAbility distinctive ring service for New
Zealand.
Additional FCC statement for telecom products (US)
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On the back
of this equipment is a label that contains, among other information, a product identier in the format
US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
The REN is used to determine the quantity of devices, which may be connected to the telephone line. Excessive
RENs on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not
all, areas, the sum of the RENs should not exceed ve (5.0). To be certain of the number of devices that may be
connected to the line, as determined by the total RENs, contact the telephone company to determine the
maximum REN for the calling area.
This equipment uses the following USOC jacks: RJ11C.
An FCC-compliant telephone cord and modular plug is provided with this equipment. This equipment is designed
to be connected to the telephone network or premises wiring using a compatible modular jack, which is Part 68
compliant. This equipment cannot be used on telephone company-provided coin service. Connection to Party
Line Service is subject to state taris.
If this equipment causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. If advance notice is not practical, the telephone company
will notify the customer as soon as possible. Also, you will be advised of your right to le a complaint with the
FCC if you believe it is necessary.
ZHTW
電信（傳真）產品的附加聲明
39