HP Color LaserJet Enterprise CP5520 - User guide

Manually configure IPv4 TCP/IP parameters from the control panel
Use the control-panel menus to manually set an IPv4 address, subnet mask, syslog server, and default
gateway.
1. Press the Home button
.
2. Press the down arrow
to highlight the Administration menu, and then press the OK button.
3. Press the down arrow
to highlight the Network Settings menu, and then press the OK
button.
4. Press the down arrow
to highlight the Embedded Jetdirect menu, and then press the OK
button.
5. Press the down arrow
to highlight the TCP/IP menu, and then press the OK button.
6. Press the down arrow
to highlight the IPv4 Settings menu, and then press the OK button.
7. Press the down arrow
to highlight the Config Method menu, and then press the OK button.
8. Press the down arrow
to highlight the Manual option, and then press the OK button.
9. Press the down arrow
to highlight the Manual Settings menu, and then press the OK button.
10. Press the down arrow
to highlight the IP Address, Subnet Mask, or Default Gateway
menu, and then press the OK button.
11. Press the up arrow
or the down arrow to increase or decrease the number for the first byte of
the IP address, subnet mask, syslog server, or default gateway.
12. Press the OK button to move to the next set of numbers, or press the back arrow
to move to the
previous set of numbers.
13. Repeat steps 10 and 11 until the IP address, subnet mask, or default gateway is complete, and
then press the OK button to save the setting.
14. Press the Home button
to return to the Ready state.
ENWW
Connect to a network
67