HP QuickPage - HP Embedded Web Server (EWS) Configuration to Enable AutoSend and Outgoing Email

5
f) Click Finish.
2. After setting the SMTP server details:
a) Navigate to General > AutoSend.
b) Select Enable AutoSend and configure to send every 1 day (as shown below).
c) Select Send to Email.
d) Provide the destination email address: [e-mail]. Replace the
“XX” (as shown here) with the 2-letter code for your country-specific email address. To
find the country-specific code, please refer to the table of email addresses at the end of
this document.
e) Click Apply.
IMPORTANT NOTE To ensure the SMTP server passes the email to external destinations, please
provide a test external email address (such as a Yahoo, Gmail, Hotmail, or other web-based
email account other than the internal company account). Click on the Test button and check for the
receipt of an email message in the test address specified confirming the compatibility of the SMTP
server. If an error message is shown at the AutoSend page or if the email does not reach your test
email account, verify with your customer technical contact (IT) that the SMTP gateway is identified
correctly in the Email Server section of the configuration. Send a test email again after any
modification to the SMTP gateway information. After successful receipt of an email on the test
account, be sure to
replace
ADDITIONAL NOTE If you are using the HP SMTP PROXY APPLICATION to act as your SMTP
Email Server Gateway, the TEST email to an external email account process will not work. Please
just enter the “meterinfo” email address and click TEST and then APPLY.
the test email address with the email address stated in step 2.d. above
and click Test and then Apply.