HP LaserJet P3010 Series - User Guide

Congure trays
NOTE: If you have used other HP LaserJet product models, you might be accustomed to conguring Tray 1 to
First mode or Cassette mode. For this product, setting TRAY 1 SIZE to the ANY SIZE setting and setting TRAY 1
TYPE to ANY TYPE is equivalent to First mode. Setting TRAY 1 SIZE and TRAY 1 TYPE to any other settings is
equivalent to Cassette mode.
The product automatically prompts you to congure a tray for type and size in the following situations:
●
When you load paper into the tray
●
When you specify a particular tray or paper type for a print job through the printer driver or a software
program and the tray is not congured to match the print-job’s settings
The following message appears on the control panel: TRAY <X> [TYPE] [SIZE] To change size or type press OK.
To accept settings press .
NOTE: The prompt does not appear if you are printing from Tray 1, and it is congured for the ANY SIZE and
ANY TYPE settings.
Congure a tray when loading paper
1. Load paper in the tray. Close the tray if you are using Tray 2, 3, or 4.
2. The tray conguration message appears.
3. Press the back arrow to accept the size and type, or press the OK button to choose a dierent paper size
or paper type.
4. To modify the tray size conguration, press the down arrow to highlight the correct size, and then press
the OK button.
5. To modify the tray type conguration, press the down arrow to highlight the correct type, and then press
the OK button.
Congure a tray to match print job settings
1. In the software program, specify the source tray, the paper size, and the paper type, and then click Print.
2. If the tray needs to be congured, the LOAD TRAY <X> [TYPE] [SIZE] message appears.
3. Load the tray with the specied type and size of paper, and then close the tray.
4. When the TRAY <X> SIZE = <Size> message appears, press the OK button to conrm the size.
To specify a custom size, rst press the down arrow to highlight the correct unit of measure. Use the up
or down arrows to set the X and Y dimensions, and then press the OK button.
5. When the TRAY<X> TYPE=<TYPE> message appears, press the OK button to conrm the type and continue
with the job.
Congure a tray by using the Paper Handling menu
1. Press the Menu button .
2. Press the down arrow to highlight the PAPER HANDLING menu, and then press the OK button.
ENWW Congure trays 85