HP LaserJet P3010 Series - User Guide
Link speed and duplex settings
The link speed and communication mode of the print server must match the network. For most situations, leave
the product in automatic mode. Incorrect changes to the link speed and duplex settings might prevent the
product from communicating with other network devices. If you need to make changes, use the product control
panel.
NOTE: Making changes to these settings causes the product to turn o and then on. Make changes only when
the product is idle.
1. Press the Menu button .
2. Open each of the following menus. Press the down arrow to highlight it and then press the OK button to
select it.
a. CONFIGURE DEVICE
b. I/O
c. EMBEDDED JETDIRECT MENU
d. LINK SPEED
3. Press the down arrow to highlight one of the following options.
Setting Description
AUTO The print server automatically congures itself for the highest link speed and
communication mode allowed on the network.
10T HALF 10 megabytes per second (Mbps), half-duplex operation
10T FULL 10 Mbps, full-duplex operation
100TX HALF 100 Mbps, half-duplex operation
100TX FULL 100 Mbps, full-duplex operation
100TX AUTO Limits auto-negotiation to a maximum link speed of 100 Mbps
1000TX FULL 1000 Mbps, full-duplex operation
4. Press the OK button. The product turns o and then on.
ENWW Network conguration 69