HP LaserJet P3010 Series - User Guide
Manually congure IPv4 TCP/IP parameters from the control panel
Use the control-panel menus to manually set an IPv4 address, subnet mask, and default gateway.
1. Press the Menu button .
2. Open each of the following menus. Press the down arrow to highlight it and then press the OK button to
select it.
a. CONFIGURE DEVICE
b. I/O
c. EMBEDDED JETDIRECT MENU
d. TCP/IP
e. IPV4 SETTINGS
f. CONFIG METHOD
g. MANUAL
h. MANUAL SETTINGS
i. IP ADDRESS, SUBNET MASK, or DEFAULT GATEWAY
3. Use the numeric keypad, or press the up arrow or the down arrow to increase or decrease the number
for the rst byte of the IP address, subnet mask, or default gateway.
4. Press the OK button to move to the next set of numbers, or press the back arrow to move to the
previous set of numbers.
5. Repeat steps 3 and 4 until the IP address, subnet mask, or default gateway is complete, and then press the
OK button to save the setting.
6. Press the Menu button to return to the Ready state.
66 Chapter 5 Connectivity ENWW