HP LaserJet P3010 Series - User Guide
Item Sub-item Values Description
COMPONENT TEST A list of available components
appears.
Activate individual parts
independently to isolate noise,
leaking, and other hardware issues.
PRINT/STOP TEST Range is 0 - 60,000 milliseconds. The
default is 0.
Isolates print quality faults more
accurately by stopping the product in
mid-print cycle, which allows you to
see where the image begins to
degrade. This causes a jam message
that might need to be manually
cleared. A service representative
should perform this test.
PRINT FUSER TEST PAGE Print this page to determine the
current status of the fuser.
SIGNATURE CHECK CANCEL IF BAD*
PROMPT IF BAD
Congure how the product responds
during a rmware upgrade if the
rmware-upgrade code does not
match the product signature.
Service menu
The SERVICE menu is locked and requires a PIN for access. This menu is intended for use by authorized service
personnel.
38 Chapter 2 Control panel ENWW