HP LaserJet P3010 Series - User Guide

Item Sub-item Sub-item Values Description
REFRESH YES
NO*
When viewing the ping test results, this item
updates the ping test data with current results. A
refresh automatically occurs when the menu
times out or you manually return to the main
menu.
LINK SPEED AUTO*
10T HALF
10T FULL
100TX HALF
100TX FULL
100TX AUTO
1000TX FULL
The link speed and communication mode of the
print server must match the network. The
available settings depend on the product and
installed print server.
CAUTION: If you change the link setting,
network communications with the print server
and network product might be lost.
AUTO: The print server uses auto-negotiation to
congure itself with the highest link speed and
communication mode allowed. If auto-
negotiation fails, either 100TX HALF or 10T HALF
is set depending on the detected link speed of
the hub/switch port. (A 1000T half-duplex
selection is not supported.)
10T HALF: 10 Mbps, half-duplex operation.
10T FULL: 10 Mbps, full-duplex operation.
100TX HALF: 100 Mbps, half-duplex operation.
100TX FULL: 100 Mbps, full-duplex operation.
100TX AUTO: Limits auto-negotiation to a
maximum link speed of 100 Mbps.
1000TX FULL: 1000 Mbps, full-duplex operation.
Resets menu
Use the RESETS menu to reset factory settings, disable and enable sleep mode, and update the product after
new supplies are installed.
To display: Press the Menu button , select the CONFIGURE DEVICE menu, and then select the RESETS menu.
NOTE: Values that have an asterisk (*) are the factory-default values. Some menu items have no default.
Item Sub-item Values Description
RESTORE FACTORY SETTINGS Clear the page buer, remove all
perishable personality data, reset
the printing environment, and
return all default settings to
factory defaults.
SLEEP MODE OFF
ON*
Select whether the product can
enter sleep mode. If you turn this
setting o, you cannot change any
settings in the SLEEP DELAY menu.
36 Chapter 2 Control panel ENWW