HP LaserJet P3010 Series - User Guide
Item Sub-item Sub-item Values Description
LAN HW TEST YES
NO*
CAUTION: Running this embedded test will
erase your TCP/IP conguration.
Perform an internal loopback test, which sends
and receives packets only on the internal
network hardware. There are no external
transmissions on your network.
HTTP TEST YES
NO*
Check operation of HTTP by retrieving predened
pages from the product, and test the embedded
Web server.
SNMP TEST YES
NO*
Check operation of SNMP communications by
accessing predened SNMP objects on the
product.
DATA PATH TEST YES
NO*
Identify data path and corruption problems on an
HP postscript level 3 emulation product. This test
sends a predened PS le to the product.
However, the test is paperless; the le does not
print.
SELECT ALL TESTS YES
NO*
Select all available embedded tests.
EXECUTION TIME [M] Specify the length of time (in minutes) that an
embedded test will run. You can select a value
from 0 to 24 minutes. If you select zero (0), the
test runs indenitely until an error occurs or the
product is turned o.
Data gathered from the HTTP, SNMP, and Data
Path tests is printed after the tests have
completed.
EXECUTE YES
NO*
Select whether to initiate the selected tests.
PING TEST Check network communications. This test sends
link-level packets to a remote network host, then
waits for an appropriate response. To run a ping
test, set the following items:
DEST TYPE IPV4
IPV6
Specify whether the target product is an IPv4 or
IPv6 node.
DEST IPV4 Type the IPv4 address.
DEST IPV6 Type the IPv6 address.
PACKET SIZE Specify the size of each packet, in bytes, to be
sent to the remote host. The minimum is 64
(default) and the maximum is 2048.
TIMEOUT Specify the length of time, in seconds, to wait for
a response from the remote host. The default is
1 and the maximum is 100.
COUNT Specify the number of ping test packets to send
for this test. Select a value from 0 to 100. The
default is 4. To congure the test to run
continuously, select 0.
34 Chapter 2 Control panel ENWW