HP LaserJet P3010 Series - User Guide
Item Sub-item Sub-item Values Description
IPX/SPX ENABLE ON*
OFF
Enable or disable the IPX/SPX protocol.
FRAME TYPE AUTO*
EN_8023
EN_II
EN_8022
EN_SNAP
Select the frame-type setting for your network.
AUTO: Automatically sets and limits the frame
type to the rst one detected.
EN_8023, EN_II, EN_8022, and EN_SNAP are
frame-type selections for Ethernet networks
APPLETALK ENABLE ON*
OFF
Congures an AppleTalk network.
DLC/LLC ENABLE ON*
OFF
Enable or disable the DLC/LLC protocol.
SECURITY SECURE WEB HTTPS REQUIRED*
HTTPS OPTIONAL
For conguration management, specify whether
the embedded Web server will accept
communications using HTTPS (Secure HTTP)
only, or both HTTP and HTTPS.
IPSEC KEEP
DISABLE*
Specify the IPSec status on the print server.
KEEP: IPSec status remains the same as
currently congured.
DISABLE: IPSec operation on the print server is
disabled.
802.1X RESET
KEEP*
Specify whether to keep the 802.1X settings on
the print server or to reset them to the factory
defaults.
RESET SECURITY YES
NO*
Specify whether the current security settings on
the print server will be saved or reset to factory
defaults.
DIAGNOSTICS EMBEDDED TESTS This menu provides tests to help diagnose
network hardware or TCP/IP network connection
problems.
Embedded tests help to identify whether a
network fault is internal or external to the
product. Use an embedded test to check
hardware and communication paths on the print
server. After you select and enable a test and set
the execution time, you must select the EXECUTE
option to initiate the test.
Depending on the execution time, a selected test
runs continuously until either the product is
turned o, or an error occurs and a diagnostic
page is printed.
ENWW Congure device menu 33