HP LaserJet P3010 Series - User Guide

Congure device menu
Use the CONFIGURE DEVICE menu for the following tasks:
●
Change the default printing settings.
●
Adjust the print quality.
●
Change the system conguration and I/O options.
●
Reset the default settings.
Printing menu
These settings aect only jobs without identied properties. Most jobs identify all of the properties and override
the values set from this menu.
To display: Press the Menu button , select the CONFIGURE DEVICE menu, and then select the PRINTING menu.
NOTE: Values that have an asterisk (*) are the factory-default values. Some menu items have no default.
Menu item Values Description
COPIES Range: 1 - 32000 Set the default number of copies for print jobs.
The default number is 1.
DEFAULT PAPER SIZE A list of available sizes appears. Set the default paper size.
DEFAULT CUSTOM PAPER SIZE
●
UNIT OF MEASURE
●
X DIMENSION
●
Y DIMENSION
Set the default size for any custom print job.
DUPLEX OFF*
ON
Enable or disable two-sided printing.
NOTE: This menu is available only on the d,
dn, and x models.
DUPLEX BINDING LONG EDGE*
SHORT EDGE
Change the binding edge for two-sided
printing.
NOTE: This menu is available only on the d,
dn, and x models.
OVERRIDE A4/LETTER NO
YES*
Set the product to print an A4 job on letter-size
paper when no A4 paper is loaded.
MANUAL FEED OFF*
ON
Makes the MANUAL FEED setting the default
for jobs that do not select a tray.
EDGE TO EDGE OVERRIDE NO*
YES
Change the printable area of Letter and A4-
size paper to 2 mm from the left and right
edges for single-sided printing. The standard
printable area is 4 mm from the left and right
edges.
ENWW Congure device menu 21