HP LaserJet P3010 Series - User Guide

Solve common Macintosh problems
Table 10-3 Problems with Mac OS X
The printer driver is not listed in the Print Center or Printer Setup Utility.
Cause Solution
The product software might not have been installed or was installed
incorrectly.
Make sure that the product .GZ le is in the following hard-drive folder:
●
Mac OS X V10.3 and V10.4: Library/Printers/PPDs/
Contents/Resources/<lang>.lproj, where <lang> is the
two-letter language code for the language that you are using.
●
Mac OS X V10.5: Library/Printers/PPDs/Contents/
Resources
If necessary, reinstall the software. See the getting started guide for
instructions.
The Postscript Printer Description (PPD) le is corrupt. Delete the .GZ le from the following hard-drive folder:
●
Mac OS X V10.3 and V10.4: Library/Printers/PPDs/
Contents/Resources/<lang>.lproj, where <lang> is the
two-letter language code for the language that you are using.
●
Mac OS X V10.5: Library/Printers/PPDs/Contents/
Resources
Reinstall the software. See the getting started guide for instructions.
The product name, IP address, or Rendezvous/Bonjour host name does not appear in the product list in the Print Center or Printer Setup Utility.
Cause Solution
The product might not be ready. Make sure that the cables are connected correctly, the product is on, and
the Ready light is on. If you are connecting through a USB or Ethernet hub,
try connecting directly to the computer or use a dierent port.
The wrong connection type might be selected. Make sure that USB, IP Printing, or Rendezvous/Bonjour is selected,
depending on the type of connection that exists between the product and
the computer.
The wrong product name, IP address, or Rendezvous/Bonjour host name is
being used.
Print a conguration page to check the product name, IP address, or
Rendezvous host name. Verify that the name, IP address, or Rendezvous
host name on the conguration page matches the product name, IP
address, or Rendezvous host name in the Print Center or Printer Setup
Utility.
The interface cable might be defective or of poor quality. Replace the cable with a high-quality cable.
The printer driver does not automatically set up your selected product in the Print Center or Printer Setup Utility.
Cause Solution
The product might not be ready. Make sure that the cables are connected correctly, the product is on, and
the Ready light is on. If you are connecting through a USB or Ethernet hub,
try connecting directly to the computer or use a dierent port.
ENWW Solve common Macintosh problems 193