HP LaserJet P3010 Series - User Guide

Table 10-1 Control-panel messages (continued)
Control panel message Description Recommended action
ACCEPT BAD SIGNATURE?
Yes press OK
alternates with
ACCEPT BAD SIGNATURE?
No press
The product is performing a remote rmware
upgrade, the rst-time code signing does not
match the signature, and the SIGNATURE CHECK
menu is set to the PROMPT IF BAD option.
Download the correct rmware upgrade le for
this product, and then reinstall the upgrade.
Access denied MENUS LOCKED The product control-panel function you are
trying to use has been locked to prevent
unauthorized access.
See your network administrator.
Action not currently available for tray x
Tray size cannot be ANY SIZE/ANY CUSTOM
Duplexing is not available when the tray size is
set to the ANY SIZE setting or the ANY CUSTOM
setting.
Change tray settings.
1.
Press the Menu button .
2. Press the down arrow to highlight the
PAPER HANDLING menu, and then press
the OK button.
3. Press the down arrow to highlight the
specied tray, and then press the OK
button.
4. Change the selected tray's size and type
settings.
BAD OPTIONAL TRAY CONNECTION An optional tray is not connected correctly. Remove the product from the tray, and reinstall
it. Then, turn the product o and then on.
Bad signature
Upgrade cancelled
The rmware upgrade code does not match the
product signature.
Download the correct rmware upgrade le for
this product, and then reinstall the upgrade.
BLACK CARTRIDGE VERY LOW The product indicates when a supply level is very
low. Actual print cartridge life might vary.
Consider having a replacement print cartridge
available to install when print quality is no longer
acceptable. You do not need to replace the print
cartridge at this time unless print quality is no
longer acceptable. After an HP supply has
reached the very low threshold, the HP premium
protection warranty for that supply has ended.
If print quality is no longer acceptable, replace
the print cartridge. See Change the print
cartridge on page 120.
Canceling... The product is canceling a job. The message
continues while the product clears the paper
path and clears any remaining incoming data.
No action is necessary.
CANNOT DUPLEX
CLOSE REAR DOOR
For help press
The rear door must be closed to duplex. Close the rear door.
Checking paper path The product is checking for possible jams or
paper that was not cleared from the product.
No action is necessary.
Checking printer The product is checking for possible jams or
paper that was not cleared from the product.
No action is necessary.
ENWW Interpret control-panel messages 151