HP LaserJet P3010 Series - User Guide
9. Reconnect the interface cables and the power cord.
10. Turn the product on.
Check DIMM installation
After installing the DIMM, make sure that the installation was successful.
1. Turn the product on. Check that the Ready light is illuminated after the product has gone through the
startup sequence. If an error message appears, a DIMM might have been incorrectly installed. See Interpret
control-panel messages on page 145.
2. Print a conguration page (see Print the information and show-me-how pages on page 106).
3. Check the memory section on the conguration page and compare it to the conguration page that was
printed before the memory installation. If the amount of memory has not increased, the DIMM might not be
installed correctly, or the DIMM might be defective. Repeat the installation procedure. If necessary, install a
dierent DIMM.
NOTE: If you installed a product language (personality), check the "Installed Personalities and Options" section
on the conguration page. This area should list the new product language.
Save resources (permanent resources)
Utilities or jobs that you download to the product sometimes include resources (for example, fonts, macros, or
patterns). Resources that are internally marked as permanent remain in the product memory until you turn the
product o.
Use the following guidelines if you use the page description language (PDL) ability to mark resources as
permanent. For technical details, see an appropriate PDL reference for PCL or PS.
●
Mark resources as permanent only when it is absolutely necessary that they remain in memory while the
product is turned on.
●
Send permanent resources to the product only at the beginning of a print job and not while the product is
printing.
128 Chapter 9 Manage and maintain the product ENWW