HP LaserJet Enterprise M4555 MFP Series-User Guide
An FCC-compliant telephone cord and modular plug is provided with this equipment. This
equipment is designed to be connected to the telephone network or premises wiring using a
compatible modular jack, which is Part 68 compliant. This equipment cannot be used on
telephone company-provided coin service. Connection to Party Line Service is subject to state
tariffs
.
If thi
s equipment causes harm to the telephone network, the telephone company will notify you in
advance that temporary discontinuance of service may be required. If advance notice is not
practical, the telephone company will notify the customer as soon as possible. Also, you will be
advised of your right to file a co
mp
laint with the FCC if you believe it is necessary.
The telephone company may make changes in its facilities, equipment, operations, or procedures
that could affect the operation of the equipment. If this happens, the telephone company will
provide advance notice in order for you to make the necessary modifications in orde
r to
maintain uninterrupted service.
If trouble is experienced with this equipment, please see the numbers in this manual for repair
and (or) warranty information. If the trouble is causing harm to the telephone network, the
telephone company may request you remove the equipment from the network until the problem is
resol
ved.
The customer can do the following repairs: Replace any original equipment that came with the
device. This includes the print cartridge, the supports for trays and bins, the power cord, and the
telephone cord. It is recommended that the customer install an AC surge arrestor in the AC outlet
to which this dev
ice is connecte
d. This is to avoid damage to the equipment caused by local
lightning strikes and other electrical surges.
Telephone Consumer Protection Act (US)
The Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a
computer or other electronic device, including fax machines, to send any message unless such
message clearly contains, in a margin at the top or bottom of each transmitted page or on the
first page of the transmission, the date and time it is se
nt and an identifica
tion of the business,
other entity, or individual sending the message and the telephone number of the sending machine
or such business, or other entity, or individual. (The telephone number provided cannot be a 900
number or any other number for which charges ex
ceed local or long distanc
e transmission
charges).
Industry Canada CS-03 requirements
Notice: The Industry Canada label identifies certified equipment. This certification means the
equipment meets certain telecommunications network protective, operational, and safety
requirements as prescribed in the appropriate Terminal Equipment Technical Requirement
document(s). The Department does not guarantee the equipment will operate to the user’s
satisfaction. Before installing this equipment, users should ensure that it is pe
rmissible for the
eq
uipment to be connected to the facilities of the local telecommunications company. The
equipment must also be installed using an acceptable method of connection. The customer should
be aware that compliance with the above conditions may not prevent degradation of service in
some situations. Repairs to certified equ
ipment shou
ld be coordinated by a representative
designated by the supplier. Any repairs or alterations made by the user to this equipment, or
equipment malfunctions, may give the telecommunications company cause to request the user to
332
附录 D 规范信息
ZHCN