HP Color LaserJet CP3525 Series Printers - User Guide

Manually configure IPv4 TCP/IP parameters from the control panel
In addition to using the embedded Web server, you can also use the control-panel menus to set an IPv4
address, subnet mask, and default gateway.
1.
Press the Menu button
.
2. Press the down arrow
to highlight the CONFIGURE DEVICE menu, and then press the OK
button.
3. Press the down arrow
to highlight the I/O menu, and then press the OK button.
4. Press the down arrow
to highlight the EMBEDDED JETDIRECT MENU option, and then press
the OK button.
5. Press the down arrow
to highlight the TCP/IP menu, and then press the OK button.
6. Press the down arrow
to highlight the IPV4 SETTINGS menu, and then press the OK button.
7. Press the down arrow
to highlight the CONFIG METHOD menu, and then press the OK button.
8. Press the down arrow
to highlight the MANUAL setting, and then press the OK button.
9. Press the down arrow
to highlight the MANUAL SETTINGS menu, and then press the OK button.
10. Press the down arrow
to highlight the IP ADDRESS menu, and then press the OK button.
-or-
Press the down arrow
to highlight the SUBNET MASK menu, and then press the OK button.
-or-
Press the down arrow
to highlight the DEFAULT GATEWAY menu, and then press the OK
button.
11. Press the up arrow
or the down arrow to increase or decrease the number for the first byte of
the IP address, subnet mask, or default gateway.
12. Press the OK button to move to the next set of numbers. To move to the previous set of numbers,
press the back arrow
.
13. Repeat steps 11 and 12 until the IP address, subnet mask, or default gateway is complete, and
then press the OK button to save the setting.
14.
Press the Menu button
to return to the Ready state.
ENWW Network configuration 71