HP Color LaserJet CP3525 Series Printers - User Guide

Control panel message Description Recommended action
This is not a recommended option because
of the risk of overfilling the toner collection
unit, which could result in the need to service
the product.
REPLACE TONER COLLECTION UNIT
To continue press OK
The toner collection unit is approaching its
estimated capacity.
Order a new toner collection unit now.
You can press the OK button to continue
printing. You can continue printing until the
continue prompt no longer appears.
Request accepted please wait The product has accepted a request to print
an internal page, but the current job must
finish printing before the internal page will
print.
No action is necessary.
Resend Upgrade The firmware upgrade was not completed
successfully.
Attempt upgrade again.
Resetting kit count You have selected the option to reset the
count for a new supply item.
No action is necessary.
Restoring factory settings The product is restoring factory settings. No action is necessary.
Restoring... The product is restoring settings. This
message is displayed during the execution of
a restore action, such as RESTORE COLOR
VALUES.
Please wait until the process is complete.
RESTRICTED FROM PRINTING IN COLOR This message appears when color printing is
disabled for the product or when it is disabled
for a particular user or print job.
To enable color printing for the product,
change the RESTRICT COLOR USE setting
in the SYSTEM SETUP menu. See
Restrict
color printing on page 122.
ROM DISK DEVICE FAILURE
To clear press OK
The specified device has failed. Press the OK button to clear.
ROM DISK FILE OPERATION FAILED
To clear press OK
A PJL file system command attempted to
perform an illogical operation.
Press the OK button to clear.
ROM DISK FILE SYSTEM IS FULL
To clear press OK
A PJL file system command could not store
something on the file system because the file
system was full.
Press the OK button to clear.
ROM DISK IS WRITE PROTECTED
To clear press OK
The file system device is protected and no
new files can be written to it.
Press the OK button to clear.
Rotating <color> Motor
To exit press
A component test is in progress; the
component selected is the <color> cartridge
motor.
Press the stop button when ready to stop
this test.
Rotating Motor
To exit press
The product is executing a component test
and the component selected is a motor.
Press the stop button when ready to stop
this test.
SANITIZING DISK <X>% COMPLETE
Do not power off
The hard disk is being cleaned. Contact the network administrator.
Table 11-1 Control-panel messages (continued)
182 Chapter 11 Solve problems ENWW