HP Color LaserJet CM1312 MFP Series - Software Technical Reference

Tray 1 and Tray 2
Dimensions
1
Weight
Capacity
2
HP LaserJet glossy paper
and HP LaserJet photo
paper
Same as the preceding listed
minimum and maximum sizes.
75 to 220 g/m
2
(20 to 58 lb)
Single sheet of HP LaserJet
glossy paper or HP LaserJet
photo paper for Tray 1
Up to 25 mm (0.99 inch) stack
height for Tray 2
HP Premium Cover
Paper
3
200 g/m
2
(53 lb) cover
Single sheet of HP Cover
paper for Tray 1
Up to 25 mm (0.99 inch) stack
height for Tray 2
Transparencies and
opaque film
Thickness: 0.10 to 0.13 mm
(3.9 to 5.1 mils)
Single sheet of transparency or
opaque film for Tray 1
Up to 50 sheets for Tray 2
Labels
4
Thickness: up to 0.23 mm (up
to 9 mils)
Single sheet of labels for Tray
1
Up to 25 mm (0.99 inch) stack
height for Tray 2
Envelopes
Up to 90 g/m
2
(up to 24 lb)
Single envelope for Tray 1
Up to ten envelopes for Tray 2
1
The product supports a wide range of standard and custom sizes of paper. Check the printer-driver for supported sizes.
2
Capacity can vary depending on paper weight and thickness, and environmental conditions.
3
Smoothness: 100 to 250 (Sheffield).
4
Hewlett-Packard does not guarantee results when printing with other types of heavy paper.
Paper Source:
The Paper source: setting specifies the source tray to use for printing a document. The list of source
trays depends on the product accessories that are installed. Any optional source trays that are installed
through the Device Settings tab also appear here.
The Paper source: drop-down menu can contain the following options:
●
Automatically Select
●
Printer auto select
●
Manual Feed in Tray 1
●
Tray 1
The default setting is Automatically Select. When this is selected, the HP Color LaserJet CM1312 MFP
Series product uses the source tray that supports the selected paper size. For the other options, make
sure the correct paper size is loaded in the source tray.
Paper type:
The Paper type: drop-down menu shows a selection of the paper types that the HP Color LaserJet
CM1312 MFP Series product supports. When you use the default setting, Unspecified, the product
uses the default paper type, which is usually Plain.
Table 6-5 Tray 1 and Tray 2 Specifications (continued)
ENWW Paper/Quality tab features 257
Engineering Details