HP Color LaserJet CM1312 MFP Series - Software Technical Reference

Click Binary to send all data except special control characters in binary (that is, 8-bit) format. The binary
formats can be sent over serial communications ports and can travel faster than data sent in the ASCII
format.
Send Ctrl-D Before Each Job
This control specifies whether the product is reset at the beginning of every postscript document. The
default setting is No. Pressing Ctrl-D resets the product to its default setting to ensure that previous print
jobs do not affect the current print job. Using Ctrl-D might cause a print job to fail if the product is
connected through a network. If the document fails to print when sent to a product that is connected
through serial ports, change No to Yes.
Send Ctrl-D After Each Job
This control specifies whether the product is reset at the end of every postscript document. The default
setting is Yes. Pressing Ctrl-D resets the product to its default setting to ensure that future print jobs are
not affected by the current print job. Using Ctrl-D might cause a print job to fail if the product is connected
through a network. If the document fails to print when sent to a network printer, change Yes to No.
Convert Gray Text to PostScript Gray
This control specifies whether to convert the true gray value (RGB) in text to the gray that the printer-
driver provides. The following settings are available:
●
Yes
●
No (default)
Convert Gray Graphics to PostScript Gray
This control specifies whether to convert the true gray value (RGB) in graphics to the gray provided by
the printer-driver. The following settings are available:
●
Yes
●
No (default)
Add Euro Currency Symbol to PostScript Fonts
This control specifies whether to add the Euro symbol to the product fonts. The following settings are
available:
●
Yes (default)
●
No
Job Timeout
This control specifies how long the document can take to get from the computer to the product before
the product stops trying to print the document. If you specify 0 seconds, the product continues trying
to print indefinitely. The default setting is 0 seconds. Use the spin box to change this value, up to a
maximum of 32,767 seconds.
Wait Timeout
This control specifies how long the product waits to get more postscript information from the computer.
After the specified time passes, the product stops trying to print the document and prints an error
ENWW Device Settings tab features 209
HP PCL 6 and universal
printer-driver (UPD) for
Windows