HP Color LaserJet Enterprise CM4540 MFP - User Guide

Telekomünikasyon (faks) ürünleri için ek bildirimler
AB Telekomünikasyon İşletim Bildirisi
Bu ürün, Avrupa Ekonomik Topluluğu (AET) ülkelerindeki/bölgelerindeki analog Kamu
Telekomünikasyon Şebekeleri'ne (PSTN) bağlanacak şekilde tasarlanmıştır.
EU R&TTE 1999/5/EC (Ek II) Yönetmeliği'ne uygundur ve üzerinde gerekli CE uygunluk işareti
bulunmaktadır.
Ayrıntılı bilgi için, bu kılavuzun başka bir bölümünde yer alan üreticinin Uygunluk Beyanı'na bakın.
Ancak, bireysel ulusal PSTN'ler arasındaki farklar nedeniyle, ürün, her PSTN sonlandırma noktasında
başarılı çalışmayı koşulsuz olarak garanti edemeyebilir. Ağ uyumluluğu, PSTN'ye bağlantı hazırlığı
sırasında müşteri tarafından seçilen doğru ayara bağlıdır. Lütfen kullanım kılavuzunda sunulan
yönergelere uyun.
Ağ uyumluluk sorunları yaşarsanız
lütfen ürün tedarikçinize veya ülkenizdeki/bölgenizdeki Hewlett-
Pac
kard yardım masasına başvurun.
Bir PSTN terminal noktasına bağlantı, yerel PSTN operatörü tarafından belirlenen bazı ek
gereksinimlere tabi olabilir.
New Zealand Telecom Statements
The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has accepted
that the item complies with minimum conditions for connection to its network. It indicates no
endorsement of the product by Telecom, nor does it provide any sort of warranty. Above all, it provides
no assurance that any item will work correctly in all respects with another item of Telepermitted
equipment of a different make or model, nor does it imply that any product is compatible with all of
Telecom’s network services.
This equipment may not provide for the effective hand-over of a call to another device connected to the
same line.
This equipment shall not be set up to make automatic calls to the Telecom “111” Emergency Service.
This product has not been tested to ensure compatibility with the FaxAbility distinctive ring service for
New Zealand.
Additional FCC statement for telecom products (US)
This equipment complies with Part 68 of the FCC rules and the requirements adopted by the ACTA. On
the back of this equipment is a label that contains, among other information, a product identifier in the
format US:AAAEQ##TXXXX. If requested, this number must be provided to the telephone company.
The REN is used to determine the quantity of devices, which may be connected to the telephone line.
Excessive RENs on the telephone line may result in the devices not ringing in response to an incoming
call. In most, but not all, areas, the sum of the RENs should not exceed five (5.0). To be certain of the
number of devices that may be connected to the line, as determined by the total RENs, contact the
telephone company to determine the maximum REN for the calling area.
This equipment uses the following USOC jacks: RJ11C.
362 Ek D Düzenlemelerle ilgili bilgiler TRWW