HP LaserJet M9040/M9050 MFP - Software Technical Reference (external)

Advanced tab features
Use the Advanced tab to change the layout of printed pages and to configure special controls that are
not commonly used. Also use this tab to control features such as media size and copies in the driver
(although most current software programs support these features in the print dialog box or through the
page settings in the software program).
Figure 4-3 Advanced tab
Paper/Output
The Paper/Output settings contain the following controls:
●
Copy Count spin box
●
Collated check box (appears when you select Copy Count)
NOTE: The Collated check box is disabled until the value for the Copy Count spin box is greater
than 1.
Copy Count
The Copy Count spin box specifies the number of copies to print. This driver setting is useful for software
programs that do not provide a copy count. If a copy count is available in the software program, set the
copy count in the software program.
The requested number of copies appears in the Copy Count spin box. Select the number by typing in
the text box or by using the up and down arrows to the right of the text box. Valid entries are numbers
124 Chapter 4 HP PCL 5, PCL 6, and PS emulation drivers for Windows ENWW