HP LaserJet M9040/M9050 MFP - Getting Started Guide

22
EN
16
To connect to a network: By default, an IP Address will automatically be assigned using DHCP. To assign a static IP address for a
network connection, do the following: On the control panel touch Administration. Scroll to and touch Initial Setup, and then touch
Networking and I/O. Touch Embedded Jetdirect, and touch TCP/IP. Touch IPV4 Settings, touch Config Method, and then touch Manual.
Touch Save. Touch Manual Settings, touch IP Address, type in the assigned IP address. Touch OK, and then touch Save.
   :  ,  µ µ  IP µ  DHCP.    µ  
IP  µ  ,   :   ,  Administration (Δ).  µ  
  Initial Setup ( µ) ,  ,  Networking and I/O (Δ  /). 
Embedded Jetdirect (µµ Jetdirect)   TCP/IP.  IPV4 Settings (µ IPV4),  Config Method
( µ µ) ,  ,  Manual ( µ).  Save ().  Manual
Settings ( µ µ),  IP Address (Δ IP),       .  OK
   Save ().
EL
  :   IP-       DHCP.   
    IP-,   .     
.       ,       /. 
 Jetdirect,  TCP/IP.    IPV4,  , . 
.   , IP-,    IP-.  OK,  — .
RU
Ağa bağlanmak için: Varsayılan olarak, DHCP kullanılarak otomatik olarak bir IP Adresi atanır. Bir ağ bağlantısı için statik IP
adresi atamak istiyorsanız, aşağıdakileri uygulayın: Kontrol panelinde Yönetim seçeneğine dokunun. İlk Kurulum seçeneğine gidin
ve dokunun; ardından Ağ ve G/Ç seçeneğine dokunun. Katıştırılmış Jetdirect ve ardından TCP/IP’ye dokunun. IPV4 Ayarları’na,
Yapılandırma Yöntemi’ne ve sonra da El ile’ye dokunun. Kaydet’e dokunun. El ile Ayarlar’a, IP Adresi’ne dokunun ve atanan IP adresini
yazın. OK’e ve ardından Kaydet’e dokunun.
TR