HP LaserJet M9040/M9050 MFP Embedded Web Server - User Guide

Navigating through the HP Embedded Web Server
To navigate through the HP EWS screens, click one of the tabs (such as Information or Settings), and
then click one of the menus on the navigation bar that is located on the left side of the screen.
The following illustration and table provide information about the HP EWS screens.
NOTE: The appearance of the HP EWS screens might differ from the illustrations in this user guide,
depending on the product features and the settings that your IT administrator has established.
Figure 1-2 Sample HP EWS screen
Table 1-1 HP Embedded Web Server
Callout HP EWS
screen feature
Description More information
1 Product name
and TCP/IP
address
View the product name.
2 Tabs Information tab View information about the
product. You cannot
configure the product
using the screens on this
tab.
See Viewing product status from the
HP EWS Information screens
on page 7.
Settings tab Use the features on this
tab to configure the
product.
See Configuring the product from the
Settings screens on page 19.
Digital Sending tab Use the features on this
tab to configure the digital
sending capabilities.
NOTE: If the Digital
Sending Software
(HP DSS) has been
installed, the digital
sending options must be
configured by using the
HP MFP DSS
Configuration Utility.
See Setting the digital sending options
on page 53.
Networking tab View network status and
configure the network
settings.
See Managing network operation from
the Networking screens on page 81.
ENWW Navigating through the HP Embedded Web Server 5