HP LaserJet M2727 MFP - Software Technical Reference

●
Printer Memory
●
Postscript Passthrough (HP postscript level 3 emulation printer driver only)
●
JPEG Passthrough (HP postscript level 3 emulation printer driver only)
Tray 3
This option specifies whether the optional Tray 3 is installed on the product. The default setting is Not
Installed.
NOTE: Tray 3 comes standard on the HP LaserJet M2727nfs.
Duplex Unit (for 2-Sided Printing)
The product comes with a duplex unit installed. This default setting is Installed.
Allow Manual Duplexing
Use this setting to allow printing on both sides of a page using manual two-sided printing. This default
setting is Enabled.
Printer Memory
This option matches the setting to the amount of memory that is installed in the product. The printer
driver generates ranges of memory that can be selected, up to the maximum that the product can accept.
The printer driver uses this information to manage the product memory.
Postscript Passthrough (HP postscript level 3 emulation printer driver only)
Postscript Passthrough is enabled by default, and must be enabled for most print jobs. Postscript
passthrough provides additional capabilities for some software programs when printing to a postscript
printer driver. Options such as Watermarks, n-up and Booklet Printing might not print correctly from
some software programs with Postscript Passthrough enabled, because such programs send
postscript information that the printer driver cannot control. Other programs might print using these
options without problems. Select Disabled and print the document again if you encounter problems.
NOTE: In some cases, disabling Postscript Passthrough can cause unexpected results within a
software program.
JPEG Passthrough (HP postscript level 3 emulation printer driver only)
The JPEG Passthrough setting contains the following options:
●
Disable. When this option is selected, images sent as .JPEG are printed as bitmaps, resulting in
faster printing.
●
Enable. When this option is selected, images sent as .JPEG are printed as .JPEG (JPEG
passthrough).
●
Auto. When this option is selected, the product connection type is automatically detected. For
network (TCP/IP) connections, JPEG passthrough is disabled. For USB connections, JPEG
passthrough is enabled.
About tab features
The About tab is in the Properties tabs for the printer driver.
282 Chapter 4 HP PCL 6 and HP postscript level 3 emulation printer drivers, and HP PCL 5 UPD for
Windows
ENWW