HP Trusted Platform Module - Installation Guide

Locate the correct connector on the formatter. The outline of a

white square the same size as the TPM is printed on the formatter and

surrounds the connector and a hole in the formatter. NOTE: The letters

AUX might not appear on some older boards. The location of the

connector on your formatter might be different from the location shown.

Hold the TPM by the edges as shown and align the connector on the

TPM with the connector on the formatter. Gently position the TPM on

the connector on the formatter. Apply slow, steady, downward pressure.

You will hear a click when the connectors are fully engaged.

Reinstall the formatter into the printer or reinstall the formatter access

cover. NOTE: It is recommended to secure the formatter with a Kensing-

ton Lock. The formatter location, appearance, access covers, and reinstal-

lation procedures might vary depending on printer. If needed, refer to the

product support page for your printer at www.hp.com/support for help.

If the optional hard-disk drive (HDD) was not removed, skip this step.

If the HDD was removed, reinstall it. If needed, refer to the product

support page for your product at www.hp.com/support for HDD

installation instructions.