User's Manual

OEM/Integrators Installation Manual
Important Notice to OEM integrators
1. This module is approved for OEM installation only.
2. This module is approved for operation in Convertible PC HSN-C09C only.
3. Additional testing and re-certification will be necessary when the conditions outlined in this OEM
installation manual are not fully satisfied.
4. The host manufacturer is responsible for additional EMI/EMC testing to verify compliance as a
composite system. When testing the host device for compliance with FCC Part 15 Subpart B/ISED
ICES-003, the host manufacturer is required to show compliance while all the transmitter module(s)
are installed and operating. The modules should be transmitting and the evaluation should confirm
that the module's intentional emissions are compliant (i.e. fundamental and out of band emissions).
The host manufacturer must verify that there are no additional unintentional emissions other than
what is permitted in the rule(s) or emissions are complaint with the transmitter(s) rule(s).
5. For RF Exposure requirement: The host manufacturer must verify that the module continues to
comply with the RF exposure limits for each host device. Preliminary assessment is normally
required to determine if additional certification for RF Exposure is needed.
End Product Labeling
When the module is installed in the host device, the FCC/IC ID label must be visible through a
window on the final device or it must be visible when an access panel, door or cover is easily
re-moved. If not, a second label must be placed on the outside of the final device that contains the
following text: “Contains FCC ID: B94-C09CWLM”; “Contains IC: 466X-C09CWLM “
The FCC ID/IC ID can be used only when all FCC/IC compliance requirements are met.
Antenna Installation
Only the same or equivalent-type as shown below may be used with this module. Other
un-equivalent types of antennas may require additional authorization for operation. The equivalent
type means the same type that results in similar in-band and out-of-band radiation patterns.
Antenna type
2.4GHz band
Peak Gain (dBi)
5.2GHz band
Peak Gain (dBi)
5.5GHz band
Peak Gain (dBi)
5.8GHz band
Peak Gain (dBi)
Couple 0.0 -1.51 -1.8 -3.34
Manual Information to the End User
The end user manual shall include all required regulatory notices as show in the following section.
Federal Communication Commission regulatory notice:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any