HP StorageWorks Fabric OS 6.1.x administrator guide (5697-0234, November 2009)

Fabric OS 6.1.x administrator guide 363
portcfgspeed [slotnumber/]portnumber, speed_level
The following example sets the speed for port 3 on slot 2 to two Gbps:
switch:admin> portcfgspeed 2/3 2
done.
switch:admin>
The following example sets the speed for port 3 on slot 2 to autonegotiate:
switch:admin> portcfgspeed 2/3 0
done.
switch:admin>
Setting the same speed for all ports on the switch
1. Connect to the switch and log in as admin.
2. Enter the switchCfgSpeed command. The format is:
switchcfgspeed speedlevel
slotnumber For bladed systems only, specify the slot number of the port to be configured,
followed by a slash (/). This operand is only required for Directors.
portnumber Specifies the port number relative to its slot for bladed systems.
speedlevel Specifies the speed of the link:
• 0—Autonegotiating mode. The port automatically configures for the
highest speed.
• 1—one Gbps mode. Fixes the port at a speed of one Gbps. Changing the
speed to one Gbps causes the port to be excluded from the trunk group.
• 2—two Gbps mode. Fixes the port at a speed of two Gbps.
• 4—four Gbps mode. Fixes the port at a speed of four Gbps. (HP
StorageWorks 4/8 SAN Switch, 4/16 SAN Switch, Brocade 4Gb SAN
Switch for HP p-Class BladeSystem, Brocade 4Gb SAN Switch for HP
c-Class BladeSystem, SAN Switch 4/32, 4/64 SAN Switch, SAN Switch
4/32B, 400 Multi-protocol Router and 4/256 SAN Director only)
• 8—eight Gbps mode. Fixes the port at a speed of eight Gbps. (HP
StorageWorks 4/256 SAN Director, 8/8 SAN Switch, 8/24 SAN Switch,
8/40 SAN Switch, and 8/80 SAN Switch and DC Directors
enterprise-class platforms with supported blades and 8 Gbps SFPs installed
only.)
speedlevel Specifies the speed of the link:
• 0—Auto-negotiating mode. The port automatically configures for the
highest speed.
• 1—one Gbps mode. Fixes the port at a speed of one Gbps. Changing the
speed to one Gbps causes the port to be excluded from the trunk group.
• 2—two Gbps mode. Fixes the port at a speed of two Gbps.
• 4—four Gbps mode. Fixes the port at a speed of four Gbps. (HP
StorageWorks 4/8 SAN Switch, 4/16 SAN Switch, Brocade 4Gb SAN
Switch for HP p-Class BladeSystem, Brocade 4Gb SAN Switch for HP c-Class
BladeSystem, SAN Switch 4/32, 4/64 SAN Switch, SAN Switch 4/32B,
400 Multi-protocol Router and 4/256 SAN Director only)
• 8—eight Gbps mode. Fixes the port at a speed of eight Gbps. (HP
StorageWorks 4/256 SAN Director, 8/8 SAN Switch, 8/24 SAN Switch,
8/40 SAN Switch, and 8/80 SAN Switch and DC Directors enterprise-class
platforms with supported blades and 8 Gbps SFPs installed only.)