HP StorageWorks Fabric OS 6.1.x administrator guide (5697-0234, November 2009)

276 iSCSI Gateway services
iSNS client service configuration
The internet storage name service (iSNS) server facilitates the automatic discovery and manages access
control of iSCSI VTs on a TCP/IP network.
iSNS clients initiate transactions with iSNS servers using the iSNS protocol, register available iSCSI VTs,
download information about other registered clients (such as iSCSI initiators), and receive notification of
events that occur in the DDs.
Figure 24 iSCSI network with iSNS server and clients
NOTE: Fabric OS supports only Microsoft iSNS Server 3.0 and higher.
Displaying iSNS client service status
1. Connect and log in to the switch.
2. Enter the fosConfig command to show the current Fabric OS configuration.
switch:admin> fosconfig --show
FC Routing service:disabled
iSCSI service:enabled
iSNS Client service:disabled
Enabling the iSNS client service
This section explains how to enable the iSNS client service and configure the iSNS server IP address.
Fabric OS supports one iSNS server connection.
NOTE: If DD and DDSets are configured on the fabric, clear the DD and DDSet configurations before
enabling iSNS client services.
1. Connect to the switch and log in.
2. Enter the fosConfig - -enable isnsc command to enable the iSNS client service:
switch:admin> fosconfig --enable isnsc
iS NS client
FC
target 1
iS NS
server
iS CS I
VT 1
iS CS I initiator
iS CS I gateway s ervice
iS NS client
IP Network
FC SAN